autocast universal
®
230 Casting System Model casting Stand 1.9. 03 A 20
Investing
For one muffle 2 x 250 g packs of rematitan
®
Plus investment
(Ord.-No. 107-600-00) are required.
Mixing ratio = 500 g : 80 ml.
Shake rematitan
®
mixing liquid (Ord.-No. 107-601-00) before
use.
For small models and a red muffle ring, and generally for
blue muffle rings, 3 x 250 g packs are used.
Mixing ratio: 250 g : 40 ml liquid.
Note:
Process rematitan
®
Plus investment at 18–22°C/64,5–72°F.
Cool the liquid in a refrigerator a 8–10°C/46,4–50°F if
necessary (not in the freezer compartment). If outside
temperatures are very high, also cool the powder.
Mix the rematitan
®
Plus investment and liquid in a vacuum
mixer for 60 seconds. Use a separate mixing beaker.
Fill the muffle to 1 mm below the edge of the sprue former.
Be sure that the surface is smooth and without bubbles.
For full upper jaws models waxed-up at an angle of 45°, brush
the undercut areas of the investment model with rematitan
®
Plus investment using a large brush, before mounting the
muffle ring. This prevents from undesired bubbles in the wax
up.
Setting time 40 minutes. Remove muffle from base and ring.
Break investment at the outer muffle edges A.
Bevel the sprue cone edge B to ensure a flat surface for the
seal.
Note C:
Do not trimm the surface with a model trimmer.
Preheating
Place investment mold in the oven with the sprue opening
facing down.
Be sure the base of the oven is clean.
Preheating oven
The oven should be equipped with a 3- to 4-sided heating
chamber and well-insulated (e.g. Protherm preheating
oven, Ord.-No. 096-170-00 and 096-180-00).
Required end temperature 1000°C/1832°F.
A programmable furnace is imperative. Circulating air
is advisable. Do not fill the oven to its capacity.
Furnaces without sufficient insulation or where the
temperature increase decrease rate is too high may cause
mould cracking.
A
B
C
Comentários a estes Manuais