Diamond Systems Pyxis-MM Manual do Utilizador

User Manual Pyxis-MM Carrier Module for GPS, Land Line Modem, and Wireless Modem Revision 1.0 November 23, 2004  Copyr

765300 - Pyxis User Manual Page 10 J13 6 pin Serial port direction selection (2x3 pin header) G PORT1 IN *GPS MAIN PORT TO PYXIS UART 1 OUT G

765300 - Pyxis User Manual Page 11 7. REGISTER MAP Note: These registers can only be accessed if the Pyxis-MM is on the PC-104 bus. Base + 0 Re

765300 - Pyxis User Manual Page 12 Base + 2 Read SWITCH CONFIG STATUS Bit No. 7 6 5 4 3 2 1 0 Name X X X X G M2 M1 M0 Definit

765300 - Pyxis User Manual Page 13 Mobile. Used with the companion SNAP2410 access point, the WIT2410 provides seamless roaming. With 16 million f

765300 - Pyxis User Manual Page 14 • LED driver outputs for visual monitoring of Carrier Detect, Transmit Data, Receive Data and DTR signals • L

765300 - Pyxis User Manual Page 15 9. SPECIFICATIONS General Power supply +5VDC +/- 10% Current consumption 198mA typical w/o OEM modules (me

765300 - Pyxis User Manual Page 2 TABLE OF CONTENTS 1. DESCRIPTION...

765300 - Pyxis User Manual Page 3 1. DESCRIPTION The product is a PC/104 carrier board that can be used to install a GPS module, a wireless modem,

765300 - Pyxis User Manual Page 4 2. THEORY OF OPERATION Pyxis-MM provides a connection for the 3 OEM modules listed to the PC-104 bus via an on

765300 - Pyxis User Manual Page 5 4. PYXIS-MM PRODUCT CONFIGURATIONS The configurations listed below are the only valid combinations of OEM module

765300 - Pyxis User Manual Page 6 Hardware Kit (DSC# 680009) 681041 Screw,4-40 x 1/4",Pan Hd,PH,Zn 8 681201 Screw, #2x56x5/8, Flat, Ph, Z

765300 - Pyxis User Manual Page 7 Land line modem connectors 1 TIP 2 RING 24 ~RESET 26 DGND 29 DCD LED 30 RX LED 31 DTR LED 32 TX LED 33

765300 - Pyxis User Manual Page 8 Serial Port Headers J5 6-pin header (1x6 right-angle pin header) for connection to Prometheus 1 TX1 2 RX1 3 GND

765300 - Pyxis User Manual Page 9 6. JUMPER SETTINGS J4 3-pin landline modem power input select (1x3 pin header) 1 +5VDC 2 POWER In to LL Modem